Installation

Thank you for purchasing this custom made quality part, made here in the USA!

ENSURE ANY FIREARM IS UNLOADED PRIOR TO WORKING ON IT! Package Contents/Directions

1. (1) Feed Tube Selector Switch (FTSS)

2. (1) two position ‘Button’, (attached)

3. (1) Replacement screw with stainless steel bushing to replace original screw.

4. (1) Flathead screw for the ‘Button’, (attached) 2mm.

Remove the original screw/switch with 2.5mm Allen wrench, use same 2.5mm to install new screw with stainless steel bushing through the FTSS, tighten down good in the center position.

When field stripping the KSG the FTSS will need to be removed, take care to retain the screw bushing.

Treat ALL Firearms as Loaded while handling, (proper mindset). Never allow ‘fun’ to trump safety with ANY firearm. The first mistake could mean someone else’s last breath on Earth. We take no responsibility for improper use of the FTSS.

There are small parts in this package, choking hazard, keep away from small children.

Pat. Pending # 62/159,719

Care of your KSG
It is very important that you take the time to break down and clean the feed tubes of your KSG, there are many complaints of them being excessively dirty straight from the factory, this in turn could cause feed issues.

We recommend after cleaning them to use a dry lube instead of oil to decrease the chance of building up contaminants that could hamper smooth functioning.

Installation Video